Skip to content Skip to sidebar Skip to footer

Which Device Parameter Does Stp Use To Select The Root Bridge?

Which Device Parameter Does Stp Use To Select The Root Bridge?. The election is based on the bridge ids (bids) sent in the bpdus. To select the path to the root the cost to the root is calculated.

Network Admin Stuff Lesson 20 SpanningTree Protocol Operation
Network Admin Stuff Lesson 20 SpanningTree Protocol Operation from ciscoiseasy.blogspot.com

Spanning tree protocol (stp) convergence (layer 2 convergence) happens when bridges and switches have transitioned to either the forwarding or blocking state. 32768 is the default value out of a range from 0 to 61440. Sstp includes all vlans on which stp is enabled in a single spanning tree.

An Election Process Takes Place, Determining Which Switch.


If all switches in a single. To select the path to the root the cost to the root is calculated. As the bpdu travels from.

Determination Of The Root Bridge On Ms Switches.


Study with quizlet and memorize flashcards containing terms like in which type of pdu will you find crc errors?, which of the following are reasons to segment a network? The mac address will determine the root bridge only if there is a tie for the switch with the lowest priority number. The single spanning tree protocol (sstp) is another type of stp.

The Switch Which Has The Lowest Bridge Id Can Be The Root Bridge,And The Bridge Id Is Made Of Priority And Mac Address,That Is , Bridge Id = Priority + Mac Address So.


The election is based on the bridge ids (bids) sent in the bpdus. Identify the root bridge in a spanning tree network. Company policy requires disabling the command history buffer on network devices.

Sstp Includes All Vlans On Which Stp Is Enabled In A Single Spanning Tree.


In my case, sw2 is the root bridge for all vlans: If there is a tie in priority then the lowest mac address will determine which bridge becomes the root. The switch with the lowest number of root ports will not be.

The Root Bridge Is Selected By Manually Configuring Its Bridge Priority To A Low Value.


Spanning tree protocol (stp) convergence (layer 2 convergence) happens when bridges and switches have transitioned to either the forwarding or blocking state. Refer to single spanning tree (sstp). As you said, if you select root bridge, it will affect whole spanning tree.

Post a Comment for "Which Device Parameter Does Stp Use To Select The Root Bridge?"